Monday, July 8, 2013

DIY Nursing tank

If you're a nursing mom, I'm sure you've tried those nursing tanks with the built in bra & hooks that detach to nurse. I found that those don't work very well for me because I'm bigger busted than around in my waist (after a few weeks postpartum) so the tanks are baggy on me and look silly under most shirts. SO I did a little research and found a great solution!  I saw the idea on Pinterest (from this blog I believe) but figured out how to do it myself. (Not that it was hard!).

Here's my step by step:

What you need:

Thread
Needle
Scissors
Spaghetti strap tank-tight fitting (without a built in bra). I think the one size camis work great!
Pins

First put your tank on its front & cut the straps off at the back where they're attached to the body (you could also probably use a seam ripper & detach but I didn't see the point in taking the extra time for that!)


Turn your tank around front facing you & measure about 1.5-2" up the straps from the body of the cami. Make this into a loop & pin. (DON'T CUT YET!!!)

Carefully try the tank on over your most used nursing bra & see if the loops will fit thru your bra clasp. I did mine about 1.5" long because I prefer it not to slide down so that if I need a little cleavage coverage with a shirt I'm wearing, this could assist.

Adjust as needed then cut strap & sew. (I'm sure you could also sew than cut if you wanted to be extra sure your length was correct.)

Done!  Took about 5-10 mins huh? Your next one will take even less time!  Now go cuddle that baby & Happy nursing!!



No comments:

Post a Comment